NanoWorld Pyrex-Nitride PNP-TRS probes are designed for various imaging applications in contact or dynamic mode and can also be used for ScanAsyst®** mode in air.
The Pyrex-Nitride TRS probes have a single silicon nitride cantilever with a very low force constant and an integrated oxide sharpened, pyramidal tip with a height of 3.5 µm. The tip is located 4 µm behind the free end of the cantilever. The probe series features a support chip that is made of Pyrex.
All chips are pre-separated prior to shipment and come in Gel-Pak containers.
The typical tip radius of curvature is below 10 nm.
Coating Description
Gold Reflex Coating
The gold reflex coating consists of a 70 nm thick gold layer deposited on the detector side of the cantilevers which enhances the reflectance of the laser beam. Furthermore it prevents light from interfering within the cantilever.
As the coating is almost stress-free the bending of the cantilever due to stress is less than 2 degrees.
Order Codes and Packages Sizes
Order Code
Quantity
Data Sheet
PNP-TRS-20
20
yes
PNP-TRS-50
50
yes
** ScanAsyst® is a registered trademark of Bruker Corporation.
Product Screencast
Product Screencast on
NanoWorld Pyrex-Nitride AFM Probes (PNP)
given by Mathieu Burri - Head of Product Development
Gel-PakВ® is a registered trademark of Delphon Industries.
** ScanAsyst® is a registered trademark of Bruker Corporation. All data are subject to change without notice.
NanoWorld AG
Rue des Saars 10
CH-2000 Neuchâtel,
Switzerland www.nanoworld.com
